Hunter AutoComp Elite, Инструкция по эксплуатации, Страница: 24 / 33

20 GETTING STARTED
3.2 Replacing Cutting Inserts
Removal
1. Disconnect the lathe AC power cord from the outlet.
2. Clean debris from heads of cutting insert screws. Do
not use compressed air.
3. Loosen and remove the # 7 Torx screw, securing the
cutting insert to the insert holder.
4. Remove the cutting insert.
Figure 45
Installation
1. Clean the insert holder with a wire brush, and the cut -
ting insert with a cloth.
2. Position and carefully seat the cutting insert on the
insert holder, with the desired cutting surface ori -
ented toward the workpiece.
3. Align the insert mounting hole with the mounting hole
in the insert holder.
4. Secure the cutting insert to the insert holder with one
# 7 Torx screw.
5. Connect the lathe AC power cord to the outlet.
3.3 Cleaning and Lubrication
Cleaning the Machine
Keep the lathe clean at all times. Pay particular attention
to the guide slides, the tool holder shaft, and the screw of
the carriage movement.
Lubrication
Lightly oil the top and bottom guide slides periodically.
Periodically grease the screw of the carriage movement
with EP grease.
The oil in the gearbox can only be checked or filled by
removing the lathe motor. With the motor removed there
is a fill plug that is removed to check the oil level.
Figure 46 Oil Fill Plug
The oil level should be halfway up the spindle at a mini -
mum, although more is allowable. If additional oil is
required, use Lubriplate Gear oil, #148-136-2.
Clean and lubricate the compensation device regularly.
Lubricate the trolley pivot regularly.
Care and Maintenance of the Compensation
Adaptor
The compensation adaptor is not a field-serviceable part.
Keep the adaptor free of debris. Should there be any evi -
dence of oil leaks, contact your service representative
immediately.
Use the BitMinder feature to keep track of bit
rotation rather than rotating only after a poor
cut. BitMinder also has a brief video
illustrating how to rotate bits.
Note position and orientation of cutting insert
holder. Rounded cut out portions of insert
holder must face inward.
Do not use compressed air to clean the brake
lathe.
Case oil fill plug