6
45039-01 • 09/16/09 • Hunter Fan Company
WARNING:
Fan may fall if not assembled as directed in these
installation instructions.
3-1. Unbundle the wires from the fan and remove the paper caution
tag. Do not discard the tag until your installation is complete.
For Standard or Angled mounting:
3-2. To assemble fan to hang down from a flat or angled ceiling,
insert the downrod through the canopy, adapter cover grommet,
adapter cover, and canopy trim ring. (The adapter cover and
adapter cover grommet may already be attached to make one
piece.) Feed the wires from the fan through the downrod.
3-3. Loosen the square-head setscrew on the adapter to install the
pipe and ball assembly.
Note:
When the pipe and ball assembly
is fully installed, 2-3 threads on the pipe will still be visible; this is
normal. Securely retighten the setscrew with a wrench or pliers.
Skip to Step 4-7.
CAUTION:
The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
For Low Profile mounting:
Note:
For low profile mounting, the downrod is replaced with the low
profile washer. The adapter cover and adapter cover grommet are not
used for low profile mounting.
3-4. Remove the set screw from the adapter.
3-5. Place the low profile washer into the canopy.
3-6. Align the holes in the washer with the holes in the adapter.
Assemble securely with three low profile screws.
Hanging the Fan:
Note:
To hang the fan, you must tilt the canopy to an almost vertical
position so that the canopy slots sit on the ceiling plate hooks.
3-7. Raise the fan and align the slots in the canopy with the hooks on
the ceiling plate.
3-8. Place the slots over the hooks to hang the fan.
Steps 3-2 – 3-3
Downrod
Canopy
Canopy
Trim Ring
Adapter
Cover
Adapter
Cover
Grommet
Setscrew
Low Profile Washer
#8-32 x 1/2” Screw
Steps 3-5 – 3-6
3 • Assembling and Hanging the Fan