Internet Thermostat
Installation Guide
If you only have an RH wire,
leave the pre-installed jumper clip in
place between the RC & RH terminals.
Install the wire under the jumper clip in the
same opening.
If you have both an RC & RH wire,
lift the RC & RH levers and remove
the pre-installed jumper clip now.
4. Reconnecting Your Wires
5. Mounting Your Thermostat
Raise the appropriate terminal levers.
Lift the levers on the terminals that match the
labels on your wires. If one of the terminals
you need has a shield in front of it, use your
finger to break the tab away.
Insert your wires and lower the levers.
Insert each wire into its corresponding
terminal. Lower the levers and push any
excess wire back into the wall.
OPTION 1
OPTION 2
Snap your thermostat
onto the wall plate.
D
Install your AA batteries.
Note:
NEVER
use
rechargeable batteries.
C
Write down your 15-digit security
code exactly as displayed.
You will need this code when you setup
your account.
B
A
Set your system switches.
Based on the type of furnace you have:
- Select Gas/Oil or Electric
- Select Heat Pump or Conventional
6. Power ON Your HVAC System Unit
You have completed your
installation!
Go to your circuit breaker panel and turn on
power to your compressor and furnace.
ON
Turn Power
Form# 44123-01
20120814
©2012 Hunter Fan Co.
EX
AMPLE
Control from any
smart phone, tablet,
laptop or desktop
computer.
my.HunterFan.com
OR
When the gateway light turns green, your thermostat will automatically connect to the internet.
modem/router
Tip:
Lift gateway antenna to improve connectivity.
7. Connect
8. Register
9. Control
If you are not sure what system
you have, contact your
HVAC manufacturer.
