Hunter 42008-01, Инструкция по установке и эксплуатации, Страница: 6 / 12

6
Hunter Fan Company 42008-01 • 12/07/05
7
42008-01 • 12/07/05 Hunter Fan Company
3 • Assembling and Hanging the Fan
You can assemble your fan for standard or angle mounting as shown
in steps 3-1 – 3-7.
3-1. Remove the label from the standard mounting washer inside the
canopy. Leave the washer in place.
3-2. To assemble the fan to hang down from a flat or angled ceiling,
insert the downrod through the canopy.
3-3. Feed the wires from the fan through the downrod.
3-4. Screw the downrod into the fan assembly.
3-5. Using the provided allen wrench, loosen the allen head set screw
on the adapter to install the pipe and ball assembly. Note: When
the pipe and ball assembly is fully installed, 2-3 threads on the
pipe will still be visible; this is normal. Securely retighten the set
screw with the allen wrench.
CAUTION: e adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
WARNING: Do not carry or lift fan by canopy.
3-6. Raise the fan and place the ball into the hanger bracket.
3-7. Align the notch on the ball with the indent in the hanger bracket.
(Rotate the fan until you hear the notch pop into place.)
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Steps 3-2 – 3-5
Downrod
Canopy
(with Washer)
Set Screw
Canopy
Standard
Mounting
Washer
Step 3-1
Label
Steps 3-6 – 3-7
Indent
Adapter
Cover
Hanger Pipe
Sleeve