40955-01 1/91
©1991 HUNTER FAN CO.™
-5-
TROUBLESHOOTING GUIDE
PROBLEM
PROBABLE CAUSE
SOLUTION
1. Nothing happens;
fan does not
move.*
2. Noisy operation.
3. Excessive
wobbling.
1. Power turned off or fuse blown.
2. Loose wire connections or wrong connections.
3. Motor reversing switch not engaged.
4. Pull chain switch not “on”.
5. Rubber shipping blocks not removed.
1. Blade brackets loosely screwed to motor.
2. Blade screwed loosely to blade bracket.
3. Blade cracked.
4. Non-approved speed control being used.
1. Blade brackets not attached at proper locations.
2. Unbalanced blades.
3. Fan too close to vaulted ceiling.
4. Loose blades or blade brackets.
5. Fan not secure on hanger assembly.
1. Turn power on or replace fuse.
2. Loosen canopy. Check all connections.
(Turn power off while checking.)
3. Push switch firmly to one side or the other.
4. Pull switch chain.
5. Remove shipping blocks.
1. Tighten screws until snug.
2. Tighten screws.
3. Replace all blades.
4. Change to approved speed control.
1. Carefully review Step 8.
2. Use balancing kit. (See Step 8E.)
3. Lower or move fan.
4. Tighten all screws.
5. Turn power off, support fan very carefully,
loosen canopy and hang correctly.
*NOTE: If blades will not turn by hand, contact your nearest service representative.
When switching from medium to low speed, you may notice some fan wobble. When fan speed stabilizes at low speed, wobble will disap-
pear. If you have checked the above problems and still have trouble, call (901) 248-2222.
NOTE: This ceiling fan may have four or five blades. If you have trouble attaching the blade brackets to the motor, carefully review Step 8.