3
©2010 Hunter Fan Co.
41773-01 20100609
1. This Air Purifier is designed for use on
a flat, level surface and may not work
properly on an uneven surface. ALWAYS
place this Air Purifier on a firm, level
surface. ALWAYS place the Air Purifier at
least six (6) inches away from walls and
three (3) Ft. from heat sources such as
stoves, radiators, or heaters.
2. Place the Air Purifier in an area that is out
of the reach of children.
3. Before using the Air Purifier, extend the
cord and inspect for any signs of damage.
DO NOT use the product if the cord has
been damaged.
4. To reduce the risk of electric shock, this
product has a polarized plug (one blade is
wider than the other) as a safety feature.
This plug will fit into a polarized outlet only
one way. If the plug does not fit fully into the
outlet, reverse the plug. If it still does not
fit, contact a qualified electrician. DO NOT
attempt to defeat or override this safety
feature.
5. ALWAYS UNPLUG the Air Purifier when it
is not in operation, while the filter is being
changed, and while it is being cleaned.
6. DO NOT tilt or move the Air Purifier while it
is in operation. Shut off and unplug before
moving.
7. DO NOT immerse the Air Purifier in water
as permanent damage will occur. Refer to
and follow the CLEANING AND FILTER
REPLACEMENT instructions.
8. DO NOT run the ionizer if tobacco smoke,
air fresheners, dripless wax candles, or
grease from cooking is present.
Save These Important Instructions
SafeTy InSTruCTIonS
uSIng your aIr PurIfIer
HEPAtech™ Filter
Front Grill
Pre-Filter
Figure 1.
1. Take the air purifier out of the box and
remove the clear plastic protective bag.
Place the unit on a firm level floor.
2. Before turning on the air purifier, you
need to confirm that the filters are firmly in
place and have not become loose during
shipping. To check the filters, first open the
front grill. Release the front grill by placing
your fingers behind the tabs and pulling
forward.
3. Next, check the HEPAtech
™
filter by
pressing firmly on all four corners of the
filter to ensure that it is fully inserted into
the filter opening.
4. The carbon pre-filter is mounted inside
the front grill with hook tape. Confirm that
it properly covers the grill vents. You may
notice a few black particles coming off the
pre-filter. Those particles are part of the
odor-removing activated carbon and will be
collected on the filter during use.
5. Place the front grill back onto the unit. First,
line up the tabs on the bottom of the grill
with the openings on the purifier base and
then push the top of the grill forward until it
is closed.
NOTE:
This unit will not operate unless the
grill is in the correct position.
6. Plug the unit into a 120V electrical outlet.
