45007-01 • 06/11/09 • Hunter Fan Company
Your Hunter fan comes with an integrated light fixture assembly.
WARNING:
Use only the light fixture supplied with this fan model.
8-1. To attach the heat shield assembly, partially install two housing
assembly screws into the switch housing mounting plate.
8-2. Feed the upper plug connector through the center opening of the
shield.
8-3. Align the keyhole slots in the housing with the assembly screws.
8-4. Turn the housing counterclockwise until the housing assembly
screws are firmly situated in the narrow end of the keyhole slots.
Install the remaining screw into the housing. Tighten all three
screws firmly.
CAUTION:
Make sure the heat shield assembly is securely
attached to the housing mounting plate. Failure to properly attach
and tighten all three assembly screws could result in the heat shield
assembly and light fixture falling.
Steps 8-1 – 8-4
Assembly
Screw
Heat
Shield
Assembly
Note:
In compliance with US federal energy regulations, this
ceiling fan contains a device that restricts the light kit to a
maximum of 190 Watts. Exceeding that limit or the marked
limit on this product may result in fire hazard or improper
operation.
8 • Completing Your Installation With a Bowl Light Fixture
11
