1
2
4
5
3
Attach the Front Wheels │ 6
Front wheel
Front axle
Front Bottom View
GAP
After assembling any wheel to the axles, please check the gap between
the screw thread and the collapsible (refer to below picture), if the gap is
too big, please add two or three washers inside the wheel, but after
tightening the nut outside the wheel, please turn the wheel by your finger
to check if the wheel can run smoothly, this is very important, because if
the wheel can run smoothly, it is ok, but if the nut press the wheel and the
wheel can’t run smoothly, the motor will be broken easily! Then you need
to decrease one or two washers to make sure the wheel can run smoothly!
Remove all the parts from the front axle.
1. Type: Slide a
Ø10 washer
onto the front axle.
2. Slide a
normal wheel
onto the front alxe.
3. Slide a
Ø10 washer
onto the front axle.
4. Tighten a
Lock nut
to the end of the front axle with a spanner.
5. “Snap” the
hubcap
to the wheel.
Repeat the above procedure to assemble the other normal wheel.
FOR ANY PRODUCT ENQUIRIES OR ISSUES PLEASE CONTACT HUNTER PRODUCTS
AT WWW.ELECTRICRIDEON.COM.AU OR TOLL FREE HELP LINE 1800 224 094.
