2
CONTROL MODULE AND HANDSET PROGRAMMING
EXPLANATION
User Manual
®
1.
Any modification or attempt to directly wire the fan without a control module will void warranty
unless those modifications are authorised.
2.
DO NOT USE ELECTRONIC OR DIMMER TYPE SPEED CONTROLLERS.
MAKE SURE THE WALL SWITCH IS ON OR REMOTE CONTROL WILL NOT WORK
Handset Battery Installation/Replacement
Open the battery compartment by sliding the hatch downwards. Gently press the grooved
section inwards to disengage latch. UNWRAP THE PLASTIC FROM AROUND NEW
BATTERIES. Observe polarity and make sure battery sits properly in recess. Slide hatch back
into place.
How To Add a New or Replacement Handset
The receiver can learn the identification code for a new handset using the following procedure:
A.
Turn off the MAINS POWER to the Control Module for 30 seconds
B.
Toggle the MAINS POWER ON and OFF as follows (each ON and OFF must be 2
secs).
C.
The Control Module will beep four times when it enters program mode. The duration
of each on period and each off period must be 2 seconds. Depending on how
accurate the 2 second periods are the Control Module should enter program mode
after 3 or 4 cycles of turning the power on/off. If the 2 second periods are too short
or too long simply keep toggling power until it does enter program mode.
NOTE:
THE MAINS POWER TO THE CONTROL MODULE MUST BE SWITCHED ON-OFF
VIA AN EXTERNAL SWITCH.
NOT
THE BUTTONS ON THE HANDSET.
D.
Move the new handset to within 2 metres of the receiver and press “LEARN” button
on the handset to add it, or the OFF button to erase all handsets from control
module memory (without any handsets the module will beep 4 times when powered)
SEE TERMS AND CONDITIONS OF WARRANTY. YOU WILL BE CHARGED A SERVICE
FEE IF THE PRODUCT IS NOT DEFECTIVE OR IS DAMAGED BY POWER SURGES,
LIGHTNING, WEATHER, MISUSE/ABUSE AND SIMILAR SITUATIONS. ALL
INSTALLATION INSTRUCTIONS MUST BE FOLLOWED.
IMPORTANT:
IF MULTIPLE FANS ARE CONNECTED TO THE SAME FINAL
CIRCUIT OR FED FROM THE SAME POWER SWITCH THEN PROGRAM THE
CONTROL MODULE BY PLUGGING IT INTO A GPO/POWER POINT BEFORE
INSTALLATION.
IMCP2-H-UM-v1.0
