REMOVE COUPLED SHADE FIRST
4 of 4
© 2018 Hunter Douglas. All rights reserved. All trademarks used herein are the property of Hunter Douglas or their respective owners.
Las Vegas • Chicago
800.229.5300
HDhospitality.com
SHADE REMOVAL
UNLOCK THE SHADES
DISCONNECT THE MOTOR
Rotate the
nut on the
idle end
countercloc
kwise to
unlock the
shade.
RELEASE THE SHADE
1
2
Disconnect the power cable
from the electrical source.
Plug-in: Unplug from the
outlet
Quick Disconnect: Unplug the
quick disconnect cables
Wired to the junction box:
Electrician is required
Open the bracket fasteners.
Turn the shade in the roll up
direction until the motor front
plate releases.
Push the shade in the direction
of the idle bracket to slide it out
of the bracket and down to
remove it completely.
Place a screwdriver between the
bracket and bearing plug and push
towards the aligner to remove the
shade. Move the shade downward
and out of the bracket. Remove the
aligner or connector from the bearing
plug.
LOCK THE SHADE
CHECK SHADE
OPERATION
UNLOCKED
LOCKED
Rotate the nut on the
idle end clockwise
until it meets the tube.
This locks the shade
into position.
Remove the tape from the shade.
Make sure the shade operates properly. Use separate
wiring information per motor type and programing
instructions from HDhospitality.com
Adjust leveler if applicable.
Sonesse 50 RTS 506S2 & 510S2 Motor
with
Coupled
7" Dual Brackets in 9" Pocket
Motorized Shade Installation Series 5-267–216
