Hunter Douglas Provenance Woven Wood Shades with PowerView Motorization, Установка, эксплуатация и уход

Страница: 17 / 28

OPERATION
15
Joining a Shade to a Group
Important:
The shade will not operate using the remote until it has been joined to a group.
note:
For shades with independent operable liner, different group numbers will need to be
programmed for the liner and the shade to operate independently.
1. Press and hold
■
STOP for 4 seconds to put remote in program mode. The lights on the
remote will flash to indicate it is in program mode.
2. Press desired group number (1 – 6) on the remote. The light for the group number selected
will flash to show it is selected.
3. Press and hold the manual control button on the shade.
4. While continuing to press the manual button, press and release
▲
OPEN on the remote.
Release the manual control button. The shade will move slightly to indicate it has joined the
group.
5. Press and hold
■
STOP for 4 seconds to exit program mode. The lights will stop flashing.
6. For shades with independent operable liner . Repeat steps for shade.
Basic Operation
1. To wake up remote, simply pick up the remote or press
■
STOP. The last group(s) selected
will be highlighted and active.
2. Press “All” or groups 1 – 6 to select specific shade(s) to move. Selected group button(s) will
light to show they are selected.
a. Multiple group buttons may be selected at a time.
b. To deselect a group, press the group button again. The backlight for that group button will
go out.
3. Press
▼
CLOSE to lower the selected shade(s).
4. Press
▲
OPEN to raise the selected shade(s).
5. Press
■
STOP to stop the shade’s movement anywhere along its travel.
6. While a shade is in motion, press the opposite of shade motion (
▲
OPEN or
▼
CLOSE) to
reverse direction.
7. Press
♥
FAVORITE to send selected shading(s) to your preset “favorite” position. Refer to the
PowerView
™
Motorization Remote Control Guide on how to set a favorite position.