Humminbird LCR 40-ID, Руководство по эксплуатации

Страница: 24 / 39

USING THE LCR
OPERATIONAL INSTRUCTIONS
Automatic Mode : In the automatic mode a continuous alarm will sound only when the
bottom depth is equal to or less than the alarm setting. Fish entering the alarm range
will not trigger the alarm unless of course the fish alarm is on.
Manual Mode : In the Manual Mode either the bottom or fish can trigger the alarm. If the
bottom depth becomes equal to or less than the alarm setting, a continuous alarm will
sound. If a fish enters the alarm range, a short, quick alarm will sound. Since the fish
alarm is active only in the automatic mode, positioning
the bottom alarm range close to
the bottom will allow you to have a fish alarm in the manual mode.
The alarm depth will adjust itself when the depth range changes from one range to
another. Thus a depth alarm set at ten feet while on the 30 foot depth range will remain
at ten feet deep should the unit advance to any other range. To set the alarm with the
most accuracy, set it using the lowest depth range.
Turn off the Bottom Alarm by again pushing the alarm “On/Off” button. The alarm setting
will then go to zero. If the alarm is turned on again before the unit is turned off it will still
be set at the previous setting.
7.
Display: Stop/Resume: Anytime during the operation of the LCR, the operator may
"freeze" the display by simply pushing the display “Stop/Resume” button. This feature
will aid in the learning and interpretation of the signal on your LCR display by giving you
time to study the display. The "Stop/Resume" will not change any original settings when
once again activated.
Note: Sensitivity and display speed may not be changed
while the display is stopped. When the “Stop/Resume” button is pressed again the
unit will resume reading at the immediate point at which the boat is sitting on the water.
8.
Display Speed: The LCR has a total of eight display speeds. When the unit is
turned on the display will be advancing at a medium speed. To increase the display
speed depress the button once or hold it down to change rapidly. An audible sound is
heard each time the speed is advanced. When the limit has been reached a chirping
sound will be heard. At this point the speed will be advancing at its maximum.
To decrease the speed, simply depress the button until the desired advance is reached.
The speed of the boat and display speed will have a large effect on the way information
is displayed. You should select the fastest display speed for high speed operation, but
use a slower display speed for idle or trolling speed.