6. If your LCR is not working properly and you suspect the problem might be in your transducer, we
would recommend you borrow a unit from a friend and try it on your boat. If the symptoms are the
same, you can almost be certain that the problem is in the transducer.
INSTALLING THE LCR
The LCR should be mounted on a flat, solid surface for maximum stability. The low profile swivel mount
has four holes drilled in the base. It is recommended that all four holes be used.
Position the swivel base and drill four ¼” diameter holes. Note: The LCR hole pattern Is the same as for
all Humminbird flasher units. Use hardware provided to mount this base to the boat.
Next place the gimbal bracket on the swivel base and attach with four small machine screws, provided.
Place the LCR in the gimbal mount and make certain the rubber washers provided are placed between
the unit and the gimbal bracket Important: Note which side of the gimbal faces forward. (Slots on
gimbal bracket go towards rear). Also, rubber washer must be located between the unit and the gimbal
bracket.
Install the mounting knobs and tighten snugly. The unit can now be swiveled and tilted to any desired
position.
