11
Confirm Sensor Connection
This section provides information on how to confirm sensor connection
and status.
System Status Bar
The system status bar is located at the top right of the display. Each
accessory connected to the control head is represented by an icon in
the system status bar. Each icon will display variations depending on
the current sensor status.
Active:
If a sensor is detected on the network and is active (transmitting
or receiving data), the icon will be white. See the table below.
Inactive:
If a sensor is connected, but not detected on the network or
active (transmitting or receiving data), the icon will be gray.
NOTE:
If you have connected an accessory to the control head and the
icon is not displaying in the system status bar, check the installation
of the accessory and the cable connection to the control head.
Active Status Icon
Sensor
Icon Description
AIS
AIS is on and receiving targets.
Compass
The selected accessory compass is on and heading data is being received.
GPS
The selected GPS source is detected and a GPS fix has been obtained.
iPilot
iPilot is connected, enabled, and actively navigating.
Radar
The selected radar source is detected and transmitting data.
2D Sonar
The selected 2D sonar source is detected and pinging data.
360 Imaging Sonar
The 360 Imaging transducer is pinging data.
Wi-Fi
Wi-Fi is on and connected to a hotspot with a strong signal strength.
system status bar
Set Up the Control Head