HumanTechnik Sonumaxx, Руководство по эксплуатации

Страница: 12 / 52

12 English
Standard components
Please check if all listed items are included:
- »sonumaxx«- Transmitter and Receiver
- Carrying cord with clip
- Screwdriver
- 12 V plug-in PSU
- Connection cable
- Operating Instructions
- Warranty card
If any parts are missing please immediately contact your dealer or the manufacturer directly.
Connecting the infrared transmitter
- Plug in the audio connection cable
1
that comes with the device into the “LINE IN” con-
nection jack of the transmitter and the other end into the connection jack of your sound
source (e.g. the TV).
Other connection adapters are available optionally: a 3.5-mm stereo cinch jack adapter
2
which can be connected to a headphone jack, or a SCART connector
3
, which can be
plugged into the SCART jack of the audio source (marked with AV).
If your sound source is not equipped with a headphone jack or any other connection op-
tions, then you can clip a microphone
4
onto the sound source. This microphone is then
plugged into the corresponding MIC jack on the transmitter. The microphone is sold se-
parately.
- Connect the power supply unit that comes with the device
5
to the transmitter using the
“DC12V” connection plug. Then plug the power supply unit itself into a 230V electrical
wall outlet.
- Set the under-the-chin receiver into the charging tray
6
of the transmitter without using
any excessive force. A red LED will light up to indicate that the device is being charged up.
- Before using the receiver for the first time, you should charge the batteries for a period of
24 hours.
Setting up or adjusting the transmitter
- Place the transmitter close to the sound source in a suitable position. There must be a
clear line of sight between the front of the transmitter (polished front surface
7
) and the
receiver
8
. The polished surface of the transmitter must be aimed at the front of the
transmitter.
How to attach the carrying cord
- The receiver includes a carrying cord, which can be attached to the rear side of the
device.
To attach the carrying cord to the receiver, place the clip on the hook
16
on the back of
the device. Now turn the clip 180° until it snaps into place. A belt clip is also available
optionally.