English 12
Delete button:
This button serves to remove
transmitters assigned to an
indicator symbol (see section
3 „Deleting transmitters from
receiver memory“).
Setting up the system
1. Connect the device
Plug the »
signolux
plug-in recei-
ver« into a well visible mains
socket.
The indicator LEDs light up once
and the device is ready to use.
The »
signolux
plug-in receiver« is
not waterproof. Therefore it is not
advisable to use it in the open.
2. Programming signals and
assignment to the symbols
A transmitter (e.g. doorbell push-
button) can be assigned to each
symbol. This assignment can
be adapted by programming.
Up to 8 transmitters can be as-
signed to each symbol. Please
keep in mind that a transmitter
can only be assigned if it is not
yet known in the memory of the
»
signolux
-pager«. If required,
you might first have to delete
the transmitter from the memory
(see section 3.)
a)
b)
c)
3. Deleting transmitters from
receiver memory
If you wish to remove the transmit-
ters assigned to a symbol from the
receiver memory:
a)
b)
Please note that this will dele-
te all transmitters assigned to
the according symbol.
Keep the function button
pressed for some time. The
symbols begin to light up in
sequence. Let go of the fun-
ction button as soon as the
desired symbol is lit. (e. g.
doorbell symbol)
Trigger the signal of the
transmitter you want to as-
sign to the lit up symbol. (e.g.
operate the doorbell button).
Wait for about 20 seconds
and test the function.
Keep the function button
pressed for a few seconds.
The symbols begin to light
up in sequence. Let go of the
function button as soon as
the desired symbol is lit.
Now press the function but-
ton and the delete button at
the same time. All symbols
will briefly light up.
