9
humantouch.com
8
Using your Human Touch Perfect Chair
is easy. Just take a seat and
adjust the chair to the desired position. The Perfect Chair cradles you
in zero-gravity comfort, with your feet above your heart—the ultimate
neutral-posture position for stress relief.
take
a seat
Adjust the headrest
While seated, reach up with both hands and grasp both sides of
the headrest. You will feel the rigid frame beneath the soft head
pad. Grasping the rigid frame, tilt the headrest forward or back-
ward for maximum comfort. The headrest remains in this position
until you adjust it again.
When adjusting the footrest up and down, you may notice a slight bumping sensation.
This is caused by the footrest locking mechanism, and is perfectly normal.
Getting out of the perfect chair
While seated, push gently forward on the electric recline lever
until the backrest automatically stops in a full upright position
and the footrest automatically stops in a vertical position (the
backrest stops before the footrest). Use the arms for support
when getting up from the chair.
Before adjusting the recline angle, be sure there is nothing located directly behind or beneath the chair.
Gently pull the electric recline lever toward you to recline, or push away from you to incline. Release the lever
when you reach the desired angle. The chair automatically stops when you reach the maximum recline or the
full upright position. In the full upright position, the legrest automatically folds inward for easy entrance and
exit from the chair.
Adjust the recline angle
NOTE:
Lean back against the backrest before reclining the chair. Do not put any extra pressure on the
footrest while reclining, as this may prevent the footrest from properly deploying and locking.
Adjusting the Lumbar Support
Your Perfect Chair comes with vertically adjustable built-in foam lumbar support. To adjust the lumbar support from
the default lower position:
Body pad
Spacer foam
HD lumbar support
1. Detach the top of the body pad from the chair, then fold it forward onto the chair seat. Or, remove the entire
body pad and place it flat, face down, on the floor.
2. Open the zipper on the upper back of the body pad to expose the foam. The blue High Density (HD) Lumbar
Support is installed in the lower position.
3. Remove the narrow spacer foam and move the HD Lumbar Support to the upper position.
4. Replace the narrow spacer foam below the HD Lumbar Support.
5. Close the body pad zipper.
6. Reattach the body pad to the chair.