Hughes NH9000, Руководство по установке

Страница: 31 / 126

Enter information about the site, satellite, antenna, and radio, as explained in this section. Enter
the values shown on the Installation Reference Sheet.
Be sure to enter the information correctly
or you may not be able to successfully install the modem
.
1. Start a web browser on your laptop computer.
2. Type
192.168.0.1
in the browser address bar and press Enter .
The System Control Center home page opens.
Note: If you see Webpage cannot be found or a similar message instead of the
System Control Center, you probably have to use a different address. See Alternate
address for installing the modem on page 99.
Figure 10: System Control Center home page
The System Status and System Info buttons are always visible near the top of the System
Control Center screens. Three additional buttons are visible after the modem has been
commissioned and is operational.
Note: The following apply to the screen illustrations in this installation guide:
• The screen illustrations are examples . Values shown in these illustrations may not
apply to the satellite modem you are installing. Do not use values shown to install
or configure the modem unless you are specifically instructed to do so.
• Most screens shown in this guide are viewed with a browser such as Internet
Explorer. However, in this guide, usually the browser is not shown (for example,
toolbars and outside edges are not shown). Also, most screen illustrations show
only the relevant part of the screen.
• On some screens and in some messages you may see the word terminal or the
abbreviation ST . Both refer to the satellite modem.
3. Click the small icon indicated by the arrow in Figure 11: Icon for opening Advanced Pages
on page 18.
17
HN9000 Satellite Modem Installation Guide
1037576-0001 Revision G
Chapter 3 Installing the satellite modem