Hughes HN9800, Руководство по установке

Страница: 61 / 66

Appendix B • Standards
1039707-0001 Revision A
61
Appendix B
Standards
The HN9800 satellite modem has been certified to comply with the standards listed
in Table 9. Additional information follows the table.
Table 9: HN9800 standards compliance
Category Standard
Safety UL60950-1 for the USA, International
CAN/CSA-C22.2 No. 60950-1 for Canada
EN60950-1 for the EU
Electromagnetic Interference (EMI FCC, Part 15 for the USA
ICES-003 for Canada
Electromagnetic Compatibility (EMC) EN 301 489-1 and EN 301 489-12 for the EU
Telecommunications TIA IPoS
Safety – Operating conditions for Canada
In addition to the warnings and safety guidelines listed in this document, the
following operating conditions apply to the HN9800 when used in Canada:
The Canadian Department of Communications label identifies certified equipment.
This certification means that the equipment meets certain telecommunications
network protective operational and safety requirements. The Department does not
guarantee that the equipment will operate to the user’s satisfaction.
Before installing the equipment, users should make sure they are permitted to
connect to the facilities of the local telecommunications company. The equipment
must also be installed using an acceptable method of connection. In some cases, the
company’s inside wiring associated with a single line individual service may be
extended by means of a certified connector assembly (telephone extension cord).
The customer should be aware that compliance with the above conditions may not
prevent degradation of service in some situations.
Repairs in Canada
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations made by
the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the
equipment.