Hughes HN9500, Руководство по установке

Страница: 125 / 136

Appendix
B
Standards compliance
The HN9500 satellite router has been certified to conform to the standards shown in Table 20:
HN9500 standards compliance on page 111. Additional information follows the table.
Table 20: HN9500 standards compliance
Standard Category
FCC Part 68 for the United States Telecommunications standards
CS-03 standard for Canada
FCC Part 15 for the United States Electromagnetic Interference (EMI) standards
ICES-003 for Canada
UL60950-1 for the United States Safety standards
CAN/CSA-C22.2 No. 60950-1 for Canada
Telecommunications standards
Certain rules concerning telecommunications apply to the HN9500 satellite router. These rules
concern ringer equivalence, discontinuance of service, repairs, and other matters. These rules
apply to the HN9500 router because it has an internal telephone modem and a phone connector
to support VADB.
FCC Part 68
Standards to which Conformity is declared: FCC Part 68
Part 68 Compliance – This equipment (two-way Hughes system: Model Number: HN9500)
complies with Part 68 of the FCC rules and requirements adopted by the ACTA. On the rear
panel of this equipment is a label that contains, among other information, the product part number
(P/N) in the format XXXXXXX-XXXX and an eight-digit Electronic Serial Number (ESN). If
requested, this information must be provided to the Telephone Company.
The two-way Hughes system must be installed according to the instructions in the installation
guide. Coaxial cables (Rx and Tx) must be grounded at the point of entry. A plug and jack used
to connect this equipment to the premises wiring and telephone network must comply with the
applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant 26 Gauge
telephone cord and modular plug is provided with this product. It is required to be terminated
with a plug type 605 or a FCC plug type 6 position for Australia.
111
HN9500 Satellite Router Installation Guide
1037736-0001 Revision G