Hughes HN
12
Acquisition Message
Informational message as returned from the AAQ about the current
acquisition.
Modem State
Indicates the modem current STFT state (numerical). Refer to the table below
(Figure 9) for each modem state.
Modem Msg:
A short description of the current STFT state
Command Result:
Message returned from the Hughes modem in reference to current
command.
Device Control Window
A Device Control Window is not needed for monitoring operation and is not included in the software.
5.
Issues and Troubleshooting
5.1.
Satellite Temporary Fixed Terminal States
Modem
State
Modem Msg
Phase
Description
Action
0
ST Rebooting
Boot,
Commissioning
Satellite Terminal is rebooting
No action
necessary
1
IDLE
None
Controller and modem/router
are not communicating
Typically this is only
during
transportation
2
Uninstalled-
Installation
Recommended
Boot
Modem/router has not been
installed properly
Have the Satellite
Terminal
professionally
installed
3
Pointing – INIT
Boot
Modem/router parameters
are intializing for pointing
No action
necessary
4
Pointing – Coarse
Boot
Coarse pointing is in process
No action
necessary
5
Pointing – FCS
Boot
Final Cell Selection
No action
necessary
6
FCS Failure
Boot
Selected cell is not viable for
this location
Must change
locaions
