8
BGAN 9201 User Manual
Needs a fix
: The LED changes to flashing red (½ duty cycle, 1 second period) indicating that
the terminal tried to register, but the GPS fix was rejected by the network.
Got a fix
: The LED changes to solid green when a new GPS fix is obtained. The LED will remain
on until the unit registers with the network and the fix is accepted. (Note that once the fix is
obtained, the GPS receiver will be turned off unless it is still downloading almanac data from
the GPS satellites)
Complete
: The LED turns off when the unit successfully registers with the network.
GPS Failure
: The LED will be solid red if the Terminal detects a hardware fault with the GPS
module.
You are now ready to Connect the Terminal to the Computer.
C
ONNECTING THE
T
ERMINAL TO THE
C
OMPUTER
You can connect your computer to the BGAN terminal with one or more of the following
interfaces
USB
Ethernet
Integrated Services Digital Network (ISDN)
WLAN
Note
There is no need to check the active interface.
All interfaces can be used
simultaneously to accommodate multiple users.
Note
During initial setup, the terminal can only be configured using either a USB or an
Ethernet connection. Once the terminal has been configured, all four interfaces
(USB, Ethernet, WLAN and ISDN) can be used for data transfer depending on the
service required.
Your computer must be configured to support your chosen connection method.
Refer to the documentation supplied with your computer for details.
