Hugh Crane COMMANDO 4000, Инструкция оператора

Страница: 8 / 22

HUGH CRANE (Cleaning Equipment) Ltd –
COMMANDO
®
4000 Page 8
BEFORE STARTING WORK :
a) Ensure the unit is standing on level ground.
b)
Check the oil level in the pump by looking at the site glass set in the end of the
crankcase of the pump and that the oil is up to the red dot when the pump is cold and
in a level position. If the oil is low top up to the correct level through the red filler cap
set in the top of the pump (use Hugh Crane Cleaning Equipment Ltd. pump oil)
c)
Fill fuel tank with clean petrol
d) Open the bleed valve on the pump
e) Open the engine fuel valve. Move the engine speed control lever to the ½ speed
position. Pull the recoil starter cord to start the engine. When starting from cold first
move the choke lever to the closed position. (Refer to the Honda Engine instruction
manual for further information).
f) Close the bleed valve on the pump.
g) Release the gun from the securing position on the frame and connect the wash lance
or tool required
h) Now operate the wash gun, by pulling the trigger on the gun, to bleed air out of the
hose until air free water is issuing from the lance.
i) Increase the engine speed to the desired working level, using the hand throttle lever
at the side of unit. Use of the throttle will directly affect output water volume and
pressure.
ENGINE STARTER
KEY SWITCH
ENGINE SPEED
CONTROL LEVER
FUEL COCK LEVER
CHOKE LEVER