background image

遙控器操作說明

 

 

- 3 - 

5. 

OFF

key to be used as “power off”.

 

6. 

OFF

key to be also used as “clear” function, when the  “OFF” key and the  “RF 

MODE” key to be pressed at the same time. 

 

B、Specification 

1. Mode: HXTC-4001 

2. Tx Frequency: 434 M Hz 

3. 12 remote control keys for melody and volume control selection 

4. Tx Power: 6.4uW 

5. Input voltage: DC 12V 

6. Working Current

0.8mA 

7. Color: different color selection. 

8.  Modulation: ASK 

9.  ta

0

℃∼

50

 

C、Operation Manual:

 

一、

 

Learning Mode 

1. Start to press the 

RF MODE

key of receiver and any key of  RF Remote 

Controller(except OFF key) at the same time. 

2. The lighting will be flashing 3-4 seconds and learning mode to be finished. 

3. Frequency limited only 

±

0.5MHZ,by Learning mode. 

 

二、

 

Leave Learning Mode

 

1. Start to press the 

RF MODE

key of receiver and the

OFF

key of  RF Remote 

Controller at the same time. 

2. The lighting will be flashing 3-4 seconds and leave learning mode to be finished. 

 

三、

 

Operation   

1. When finish the learning mode, and then you can use it as you wish accordingly. 

 

四、

  

 Caution 

     1. Please don't put battery inside Controller, when it is not used any more. 

2. Please put upper cover back after replace battery.  

3. Please don't put Controller in the Moist place. 

 

 

 

Содержание HXTC-4001

Страница 1: ...emote Controller Function Specification USER MANUAL FCC ID QKUHXTC 4001 Co Address No 293 Hwa Shin St Chu Pei City Hsin Chu 302 Taiwan Factory Address No 9 Fu Guei St Ju Dung Hsin Chu 310 Taiwan Tel 886 3 5827899 FAX 886 3 5836582 Web www hugewin com tw ...

Страница 2: ...mote Controller A Profile 1 There are 12 keys in the front side and only 8 figure keys 1 8 to be available to control melody or choose lighting flash mode 2 P key to be used as Polling to choose different melody or lighting flash mode 3 V key to be used as the melody s volume control 4 ON key to be used as power on ...

Страница 3: ...ver and any key of RF Remote Controller except OFF key at the same time 2 The lighting will be flashing 3 4 seconds and learning mode to be finished 3 Frequency limited only 0 5MHZ by Learning mode 二 Leave Learning Mode 1 Start to press the RF MODE key of receiver and the OFF key of RF Remote Controller at the same time 2 The lighting will be flashing 3 4 seconds and leave learning mode to be fini...

Страница 4: ...th the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following ...

Отзывы: