Huffy Universal Elevator Mount Скачать руководство пользователя страница 1

1

10/01

P/N 211125A

Customer Service Center

N53 W24700 South Corporate Circle

Sussex, WI 53089

U.S.A.

A Huffy Company

Required Tools and 

Materials:

NOTE: Due to various mounting

methods, additional tools and
materials may be required.

•   Two People

•   Tape Measure

•   Pencil

•   Wrenches: (Two) 7/16”, 1/2”,

9/16”, 3/4”

or Large and Small Adjustable 

Wrenches

•   Step Ladder 8 ft. (2.4 m)

• Drill & Bit (3/8”)

• Carpenter Level

Universal Elevator Mount Owners Manual

printed on recycled paper

Toll-Free Customer Service Number for U.S: 

1-800-558-5234

and Canada Only:  

1-800-284-8339

Internet Address:

http://www.huffysports.com

WRITE IN YOUR MODEL NUMBER:

SAFETY INSTRUCTIONS

FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY

RESULT IN SERIOUS INJURY,

PROPERTY DAMAGE AND WILL VOID WARRANTY.

Owner must ensure that all players know and  follow these

rules for safe operation of the unit. 

To ensure safety, do not attempt to assemble this system without
following the instructions carefully. Check entire box and inside all
packing material for parts.  Before beginning assembly, read the
instructions and identify parts using the hardware identifier and parts
list in this document. Proper and complete assembly, use and
supervision are essential for proper operation and to reduce the risk of
accident or injury.  A high probability of serious injury exists if this
system is not installed, maintained, and operated properly. 

•  This equipment is intended for home recreational use only and NOT 

excessive competitive play. 

Read and understand the warning label enclosed with hardware.  It is

the responsibility of the customer to mount this label.  It should be

affixed to the pole, wall, or door near playing area, at a height between 

4-6 feet (1.2 -1.8 m)  above ground level and in a location visible to all

players. 

During assembly, if using a ladder use extreme caution.  Two people are

recommended for this operation. 

If technical assistance is required, contact Huffy Sports. 

Adult supervision is recommended when adjusting height. 

Most injuries are caused 

by misuse and/or 

not following instructions.  

Use caution when using this unit.  

IMPORTANT!  

Have questions...don’t go back to the store! 

We appreciate your purchasing one of our many fine products.  We are sure that you will be very satisfied with your selection.  Although
great care and effort have been taken, occasionally problems may occur.  To ensure prompt and correct handling of any problems, or to
answer any questions, please contact our Toll-Free Customer Service Number listed below. 

Service will be quicker if you have your

Model Number (found on carton) and assembly instructions ready when calling.  PLEASE WRITE YOUR MODEL NUMBER IN
THE SPACE PROVIDED ABOVE.

Содержание Universal Elevator Mount












Отзывы: