8
Installing the Drive Motor and Rear Wheels
Assembly
Spanner
Rear axle
Spanner
Washer assembled
already
17
16
16
17
15
11
18
10
15
9
15
1. Slide the Motor (9) onto the rear axle (right side).
2. Feed the Plug and Wires through motor hole.
3. Slide the Drive Wheel (10) onto the rear axle. Ensure the
Drive Wheel Gear
matches with the
Motor Gear Inset
.
4. Slide Washer (15) onto the rear axle.
5. Install Locknut (16) securely on the end of the rear axle with Spanner Wrench.
1. Slide Washer (15) onto the rear axle.
2. Slide the Bushing (18) into the indent in the back of the Wheel (11) (it will sit even
with the back of the wheel).
3. Slide the Wheel onto the rear axle. Ensure Bushing stays in place in Wheel.
4. Slide Washer (15) onto the rear axle.
5. Install Locknut (16) securely on the end of the rear axle with Spanner Wrench.
Hint: An extra Spanner has been provided to hold the locknut on one side of the
rear axle while tightening the locknut on the other side.
6. Align the two tabs of the Hubcap (17) with the slots of the wheel cover, and press
the Hubcap fi rmly into place.
Repeat this step for the other side.
Attach the Left Rear Wheel
Attach the Drive Wheel
NOTE: Begin by turning the vehicle upside down.
