8
•
ALWAYS
inspect your log splitter before each use. Make sure all nuts, bolts, screws,
hydraulic fittings, hose clamps, etc. are securely tightened.
•
ALWAYS
check the oil level in the hydraulic oil tank and engine reservoir.
•
NEVER
operate your log splitter when it is in need of repair or is in poor
mechanical condition.
•
NEVER
tamper with the engine to run it at excessive speeds. The maximum
engine speed is preset and is within safety limits.
•
NEVER
make alterations to your log splitter in any manner. Such alterations
may cause the log splitter to become unsafe and
WILL VOID THE WARRANTY.
•
NEVER
attach a rope or extension to the control lever or add width or height to the
splitting wedge. Such
ALTERATIONS
may cause the log splitter to become
UNSAFE
and
WILL VOID THE WARRANTY
.
•
ALWAYS
clean the unit after each use. If possible, store the unit inside or cover
Towing
•
ALWAYS
check before towing to make certain your log splitter is correctly and
securely attached to the towing vehicle. Be sure that the ball hitch you are using is the
proper size for the hitch coupler on the log splitter . Be sure the safety chains are
properly hooked to the vehicle leaving enough slack for turning.
Log Splitting Safety
•
ALWAYS
keep your fingers away from any cracks that open in the log during the
splitting operation.
•
ALWAYS
make sure that both ends of the log you are splitting are cut as square as
possible. This will prevent the log from sliding out of position while under pressure.
Logs should be 24 inches or shorter in length.
•
NEVER
try to split two logs on top of each other.
•
NEVER pile logs to be split in a manner that will cause you to reach across the log
splitter.
Maintenance and Repair
•
Follow
ALL
safety rules, because most accidents involving the operation,
maintenance, or repair of products occur because the assembler/owner/operator failed
to observe basic safety rules or operating instructions.
