Huck AEROBOLT 10256, Руководство пользователя

Страница: 4 / 12

Page 4 of 12
When the Trigger is depressed (1), the Throttle Valve
moves to the down position (2), and pressurized air is
directed to the bottom of the Air Piston, causing it to
move upward (3). The air above the Piston is
exhausted and directed through the center of the
Throttle Valve and out the bottom of the tool (4). The
Air Piston has a Rod and a Hydraulic Piston attached.
When the Air Piston rod moves upward, a column of
pressurized hydraulic fluid is forced up (5)
into the tool head, which moves the Pull Piston back (6).
The attached nose assembly moves with the Pull Piston
to start fastener installation. When fastener installation
is completed, the Trigger is released (7). Air pressure,
with the assistance of a Spring (8), causes the Throttle
Valve to return to its up position (9). Pressurized air is
re-directed to the top of the Air Piston, causing it, along
with the Hydraulic Piston Rod, to move downward (10).
The air from below the Air Piston is exhausted through
the bottom of the tool (11). As this occurs, hydraulic
pressure is reversed and the Pull Piston is returned
forward (12). A return pressure relief valve protects the
tool against pressure spikes. The reservoir replenishes
the hydraulic system as needed.
Specifications
POWER SOURCE:
110 psi MAX shop air
HOSE KITS:
Use only genuine HUCK Hose Kits
rated @ 10,000 psi working
pressure.
HYDRAULIC FLUID:
Hydraulic fluid shall meet
DEXRON®
III, DEXRON VI, MERCON, Allison C-
4 or equivalent ATF specifications.
Fire resistant fluid may be used if
it is an ester based fluid such as
Quintolubric HFD or equivalent.
Water based fluid shall NOT be
used as serious damage to
equipment will
occur.
WEIGHT: 11.1 lbs (5.03 kg)
MAX OPERATING TEMP:
125°F (51.7°C)
SPEED/CYCLES: 30 per minute
MAX FLOW RATE:
22.4 scfm (634 l/m)
MIN PULL CAPACITY:
9986 lbs (44.42 kN) @ 90 psi
MAX INLET PRESSURE:
110 psi (6.2 bar)
MIN STROKE:
.875 inches (2.22 cm)
.750 inches (1.91 cm) when used
with
Stroke Limiter 118362-1
Where the following trade names are
used in this manual, please note:
DEXRON is a registered trademark of
General Motors Corporation. Loctite is a
registered trademark of Henkel
Corporation, U.S.A. LUBRIPLATE is a
registered trademark of Fiske Brothers
Refining Co. MERCON is a registered
trademark of Ford Motor Corp. Never-
Seez is a registered trademark of Bostik,
Inc. Quintolubric is a registered
trademark of Quaker Chemical Corp. Slic-
tite is a registered trademark of LA-CO
Industries, Inc. Spirolox is a registered
trademark of Smalley Steel Ring
Company Teflon is a registered
trademark of E. I. du Pont de Nemours
and Company. Threadmate is a registered
trademark of Parker Intangibles LLC.
TRUARC is a trademark of TRUARC Co.
LLC. Vibra-Tite is a registered trademark
of ND Industries, Inc. USA.