Hublot BigBang, Инструкция по эксплуатации

Страница: 7 / 11

13 12
1 2
SETTING THE TIME
INTRODUCTION
This function enables you to set the time using the crown positioned at 3 o'clock.
FONCTIONNEMENT
1. Loosen and pull the crown into position
2 (time-setting).
2. Turn the crown clockwise (ideally) to set
your watch to the desired time.
3. Push the crown back against the case,
into position 1 (winding) and tighten the
crown.
E
N
G
LI
SH
USING THE CHRONOGRAPH
INTRODUCTION
This function enables you to measure time using the two push-pieces positioned at 2 o'clock (Start/
Stop) and 4 o'clock (Reset).
OPERATION
Before timing, make sure that the chronograph
centre hand (direct-drive), and the minute and
hour counter hands have been reset. Then :
1. Press push-piece (A) : the chronograph
hand will start instantly.
2. When the event ends, press push-piece
(A) : the hand will stop and display the exact
elapsed time.
3. Press push-piece (B) : the direct-drive hand
and counter hands will be reset.
To measure a series of sequential times : press
push-piece (A) again to restart the hands.
NB : the chronograph can only be reset if it has
first been stopped by pressing push-piece (A).
A
B