Huber Profibus SE, Технический бюллетень

Страница: 7 / 14

Installation instructions
Chapter 3 TECHNICAL BULLETIN
V1.2.0en/05.02.16 Liability for errors and misprints excluded. Profibus® Gateway SE
7
3 Installation instructions
3.1 Installation provided by the customer
The Profibus Gateway SE is installed in a stainless steel housing with a mains socket for fee-standing
installation or for hanging it to the side wall of the device. The device is connected via a 3 m RS-232
cable.
The Profibus cable with D-SUB 9 connector is routed directly to the Profibus Gateway SE. The user
must guarantee compliance with the Profibus parameters and the bus topology in accordance with
the requirements of the PROFIBUS user organization. A bus termination can be enabled on the Pro-
fibus Gateway SE. The Profibus Gateway SE has been built and qualified in accordance with the spec-
ifications of the PROFIBUS user organization. The customer must comply with the applicable stand-
ards for the internal wiring of the device. This applies in particular to a well-functioning functional
earth and potential equalization.
4 Commissioning of the Profibus Gateway SE
There are five controls on the front side of the Profibus Gateway SE. These must have the following
positions:
Element Position
S4 0
S5 0
Termination Depending on the position of the Profibus Gateway SE within the bus
ID High
Profibus slave address
ID Low
Position of the control
elements