Huber KISS 1 Series, Руководство по эксплуатации

Страница: 24 / 56

Commissioning
OPERATION MANUAL Chapter 2
KISS Immersion Circulator
V1.2.0en/11.12.20//0.3.1
24
Use of unsuitable/defective hoses and/or hose connections
INJURIES

Thermal fluid

Use appropriate hoses and/or hose connections.

Check periodically for leaks and the quality of the hose and hose connections and take suitable
measures (replace) as required.

Isolate and protect temperature control hoses against contact/mechanical load.

Cooling water

Reinforced hoses must be used to satisfy tougher safety requirements.

Shut off the cooling water supply to the temperature control unit even for shorter downtimes
(e.g. overnight).
Steam or hot water escapes at the >cooling coil< [29]
SEVERE BURNS

Do not use the >cooling coil< [29] at bath temperatures > 95 °C.

Provide a greater flow rate through the >cooling coil< [29] at bath temperatures > 60 °C.
No protection against corrosion
DAMAGE TO THE TEMPERATURE CONTROL UNIT

The addition of anti-corrosion agents is mandatory if salts (chlorides, bromide) have been
added to the water circuit.

Ensure that the materials used in the cooling water circuit are resistant with respect to the
cooling water. See the data sheet from page 58 in section
»Annex«
for information on the ma-
terials used.

Take suitable measures to maintain the warranty conditions.

For information about water quality, see www.huber-online.com.
Usage of un-filtered river/sea or ocean water as cooling water
DAMAGE TO THE TEMPERATURE CONTROL UNIT

Un-filtered river or sea water is not suitable for use as cooling water due to its contaminants.

Use drinking water or filtered river or sea water for cooling.

Sea water must not be used for water cooling.

For information about water quality, see www.huber-online.com.
The
>Cooling coil<
[29] scales at cooling water temperatures > 60 °C according to the wate r quali-
ty. Descale regularly and on time. On page 15 observe Section »Proper disposal of resources and
consumables«
.
Observe all legal and other requirements specified by your water supplier when connecting to the
public water system.
To reach temperatures close to the ambient temperature a >cooling coil< [29] is required. In some
types of temperature control units the >cooling coil < [29] is pre-assembled and for other types it is
available as an accessory (see the connection diagram on page 58 in section »Annex« ).
PROCEDURE

Connect one of the connectors to your cooling water inlet and the other to your cooling water
return flow (no preferred direction).

Only use the
>cooling coil<
[29] at bath temperatures at less than 95 °C.

Provide sufficient flow at high bath temperatures (between 60 °C and 95 °C) to prevent excessive
scaling of the
>cooling coil<
[29] and the return line.

Shut off the cooling water supply during heating. You will save energy and achieve shorter heat-
ing times.