Page 2
KIM Lighting • P.O. Box 60080 • 16555 E. Gale Ave. • City of Industry, CA 91716-0080 • 626/968-5666 • FAX 626/330-3861
The Path Pilot
®
- KLV 101/106
Installation Instructions
6. Replace globe, louvers (KLV106
only), top cap and screws.
KIM LIGHTING LIMITED WARRANTY
When installed in accordance with Kim Installation Instructions and accepted
trade practices, the following shall apply:
General Product Limited Warranty Coverage
All material and component parts used in the manufacture of Kim Products,
are warranted to be free from defects of material and/or workmanship for a
period of 1 year from date of sale, with the following exceptions:
Auxiliary Equipment
All auxiliary equipment (such as lamps, ballasts, and transformers) provided
by and/or included in Kim Products shall carry the component manufacturer's
warranty.
Copper and Bronze Landscape Components
Copper and Bronze Landscape fixture components shall be warranted
against defects of material and/or workmanship, and failure due to corrosion,
for a period of 25 years from date of sale.
Composite In-Ground Components
Composite In-Ground fixture components installed below grade, shall be
warranted against defects of material and/or workmanship, and failure due to
corrosion, for a period of 7 years from date of sale.
Aluminum Landscape Components
Aluminum Landscape fixture components not in direct contact with soil, shall
be warranted against defects of material and/or workmanship for a period of 3
years from date of sale. Aluminum fixture components in direct contact with
soil shall be warranted from defects of material and failure due to corrosion for
a period of 1 year from date of sale.
Limit of Liability and General Conditions
Only products which are installed, used and maintained in accordance with
applicable Kim instructions, specifications and accepted trade practices, are
covered by the Kim Warranty. During the warranty period, with proof of
purchase, Kim will repair or replace with the same or similar product, at Kim's
option, without charge. Labor costs are the owner's responsibility and are
excluded from this warranty. This warranty is void if the product is modified,
tampered with, misapplied, poorly installed, improperly maintained, or
subjected to abnormal conditions.
Repair or replacement as provided under this warranty is the exclusive
remedy of the purchaser. This warranty is in lieu of all other warranties,
expressed or implied, including any implied warranty of fitness for a particular
application. Kim Lighting shall not be liable to the purchaser for indirect or
consequential damages.
KLV106
KLV101
7. Connect fixture cable to main
system cable with a KLV410
Sealed Connector.
(See KLV410
Sealed Connector
Installation
Instructions)
Caution:
Always coat screws with
grease before reinstalling after initial
installation or future relampings.
Failure to do so could cause screws
to freeze up and become
unremovable.
Install fixture in
desired location.
How may we serve you better?
Please let us know. Visit our website at:
www.kimlighting.com
Your concerns are important to us.
Lamp
(T-4)
Gasket
5. Observe warnings and cautions.
Install lamp of type and wattage
shown on fixture label and chart
below.
Remember, the total
wattage of all lamps connected
to one transformer must not
exceed the capacity of that
transformer.
LAMP INFORMATION
Cat. No. Lamp Type
Max. Watts
Base
KLV101
T-4 Bipin
35
GY6.35
KLV106
T-4 Bipin
50
GY6.35
To Relamp turn off/unplug and allow
to cool before replacing lamp.
Replace per chart. Lamp gets hot
quickly. Contact only switch or plug
when turning on.
Additional wire and connectors may be
purchased fromKim Lighting:
KLV427 #12-2 Cable
KLV432 #8-2 Cable
KLV410 Connector
KLV411 Connector