Page 2 Kim Lighting • 16555 E. Gale Ave. • P.O. Box 60080 • City of Industry, CA 91716-0080 • 626/968-5666 • FAX 626/369-2695
Wall Forms
®
Round - WF30H Series
Installation Instructions
KIM LIGHTING LIMITED WARRANTY
When installed in accordance with Kim Installation
Instructions and accepted trade practices, the following
shall apply:
General Product Limited Warranty Coverage
All material and component parts used in the
manufacture of Kim Products, are warranted to be free
from defects of material and/or workmanship for a period
of 1 year from date of sale, with the following exceptions:
Auxiliary Equipment
All auxiliary equipment (such as lamps, ballasts, and
transformers) provided by and/or included in Kim
Products shall carry the component manufacturer's
warranty.
Copper and Bronze Landscape Components
Copper and Bronze Landscape fixture components shall
be warranted against defects of material and/or
workmanship, and failure due to corrosion, for a period of
25 years from date of sale.
Composite In-Grade Components
Composite In-Grade fixture components installed below
grade, shall be warranted against defects of material
and/or workmanship, and failure due to corrosion for a
period of 7 years from date of sale.
Aluminum Landscape Components
Aluminum Landscape fixture components not in direct
contact with soil, shall be warranted from defects of
material and/or workmanship for a period of 3 years from
date of sale. Aluminum fixture components in direct
contact with soil shall be warranted from defects of
material and failure from corrosion for a period of 1 year
from date of sale.
Limit of Liability and General Conditions
Only products which are installed, used and maintained
in accordance with applicable Kim instructions,
specifications and accepted trade practices, are covered
by the Kim Warranty. During the warranty period, with
proof of purchase, Kim will repair or replace with the
same or similar product, at Kim's option, without charge.
Labor costs are the owner's responsibility and are
excluded from this warranty. This warranty is void if the
product is modified, tampered with, misapplied, poorly
installed, improperly maintained, or subjected to
abnormal conditions.
Repair or replacement as provided under this warranty is
the exclusive remedy of the purchaser. This warranty is
in lieu of all other warranties, expressed or implied,
including any implied warranty of fitness for a particular
application. Kim Lighting shall not be liable to the
purchaser for indirect or consequential damages.
MAINTENANCE
Make certain electricity is
OFF
.
1. To replace lamp, proceed as follows:
a.
Remove diffuser frame assembly.
b. Replace lamp with type and wattage shown on fixture
label.
c. Clean lens and diffuser frame gasket.
d. Coat diffuser frame screws with silicone grease and
install diffuser frame assembly. Tighten the four
screws progressively and evenly to insure even gasket
sealing around the frame.
Do not
exceed 20 in-pound
torque on these screws.
2. To replace electrical assembly, proceed as follows:
Make certain electricity is
OFF
.
a. Remove diffuser frame assembly and lamp.
b. Loosen the three (3) mounting screws securing
electrical assembly to housing. Remove electrical
assembly and unplug quick disconnect plug
assemblies.
c. If ballast type and/or watts are not the same as
replaced equipment, mark fixture label in housing to
correspond with new ballast information.
d. Connect quick disconnect plug assemblies.
e. Install the electrical assembly into the housing &
tighten screws.
f. Screw the proper lamp (as per fixture label) into the
socket and tighten the lamp sufficiently to ensure a
vibration safe installation.
g. Clean lens and diffuser frame gasket.
h. Coat diffuser frame screws with silicone grease and
install door frame assembly. Tighten the four screws
progressively and evenly to insure even gasket seating
around frame.
Do not
exceed 20 in-pounds torque on
these screws.
!
!
Diffuser
Diffuser
*Diffuser
Cat. No.
Type
Part No.
Gasket
Frame Assy.
WF30
Smooth
84133
85625
Prism
84136
85626
WF31
Smooth
84133
85627
Prism
84136
85628
WF32
Diffused
84140
82302
85629
WF33
Diffused
84141
82302
85630
WF 30
WF 31
WF 32
WF 33
REPLACEMENT PARTS LIST
*NOTE:
When ordering a diffuser frame give model and
finish i.e., WF32/BL-P
82291
82291
How may we serve you better?
Please let us know. Visit our website at:
www.kimlighting.com
Your concerns are important to us.
WARNING:
This H.I.D. / Fluorescent fixture utilizes a lamp that may
contain mercury. For information on disposal of lamp, go to
website:
www.lamprecycle.org