Page 2
Kim Lighting • 16555 E. Gale Ave. • P.O. Box 60080 • City of Industry, CA 91716-0080 • 626/968-5666 • FAX 626/330-3861
LIGHTVAULT
®
LENS REFLECTOR - LTV59 / LTV759
Installation Instructions
7. Loosen tilt adjustment screws, aim reflector to desired
orientation and lock position by tightening tilt
adjustment screws.
8. NOTE: After installing lamp let fixture warm up for
5 minutes before completely closing. Install
eyeball lens frame, lens and gasket making sure
surface is clean and dry. (See Note above.)
1
2
3
4
4. Install lamp lead connections to fixture connection.
5. Grease threads before installing eyeball onto
housing. (See step below) Install eyeball onto
housing (making sure eyeball will be facing desired
position), and tighten opposing screws progressively
and evenly until tight.
NOTE: Eyeball will mount in 8
directions @ 45° increments.
Note: Make sure gasket and gasket surface is clean
and dry. Make certain no dirt has fallen into screw
holes. Any foreign object trapped in the gasket areas
will create potential points of entry for ground water.
5
1
2
3
4
6
7
8
6. Remove eyeball frame, lens and gasket.
Coat screws with silicone grease and tighten
opposing screws progressively and evenly unti tight.
Any foreign object trapped in gasket areas will create
potential points of entry for ground water.
For Steps 5 and 8:
