Page 3 of 5
3940 Dr. Martin Luther King Drive
St. Louis, MO 63113
P/N 00912336 FORM NO. K1225 R09/16 ECO-7-023-16
4. Loosen switch terminal screws and wrap
stripped conductors securely around the
terminal screws. Tighten the terminals to the
values per table.
5. Connect the ground terminal securely and
tighten to the values shown in table.
Inspect & clean the machined flange joint
surface
of both the cover & box. Surface must
be smooth, free of nicks, scratches, dirt, or any
foreign particle build-up that would prevent a
proper seal. Surfaces must seat fully against
each other to provide proper joint. Clean
surfaces by wiping with a clean, lint free cloth.
Apply a light coating of “LUBG” lubricant to
flange surface and close the cover. Install and
tighten all cover bolts to 25 ft. lbs. Make sure
no cover bolts are omitted. Use only those bolts
supplied with the device.
2. OPERATION
CAUTION
: The plug assembly cannot be
removed until the handle is in the “
OFF
”
position. The switch cannot be turned “
ON
”
without the plug inserted into the receptacle.
NOTE
: Refer to the label attached on the
operator housing of the receptacle assembly.
Plug Insertion
: While inserting the plug into
the receptacle the release button will snap into
place locking the plug into the receptacle.
Switch Control
: The switch can be turned “
ON
”
when the plug is inserted. The plug is locked
in receptacle when the unit is turned “
ON
”.
The switch handle can be locked in the “
OFF
”
position.
Plug Removal:
Turn “
OFF
” the switch. Pull
out the release button while removing the plug
from the receptacle (Refer to the label attached
on the operator housing of the receptacle
assembly).
3. ELECTRICAL TEST BEFORE
ENERRGIZING
Do not connect to power before conducting the
following electrical tests:
•
Test continuity of wiring to verify correct
polarity, phasing and grounding connections.
•
Measure insulation resistance to be sure the
system does not have any shorts or unwanted
grounds.