Pub. 42004-429C
ICS/SP2 Page/Party
®
Desktop Subset
Page 3 of 5
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-429C.docx
01/20
N
OTE
:
The desktop subset can be placed on a desk or wall mounted.
Wall-Mount Installation
To mount the subset on a vertical surface:
1.
Remove the four screws from the bottom of the subset’s housing.
2.
Rotate the bottom section of the housing 180º.
3.
Reassemble the top to the bottom with the four screws.
4.
Pull out the handset hook and rotate it 180º.
This allows the handset to remain on hook when wall mounted
5.
Mount the subset in the desired location.
6.
Continue with step two of the desktop installation instructions below.
Desktop Installation
1.
Place the subset at the desired location.
2.
Plug the interconnect cable into the subset and tighten the thumbscrews on the DB25 connector.
3.
Route the opposite end of the cable to the remote amplifier location.
4.
Plug the interconnect cable into the remote amplifier and tighten the thumbscrews on the DB25
connector.
Figure 3. Typical Desktop Installation