Pub. 42004-642L2F
711-102 and 7115-102 Desk-Edge Subsets
Page 4 of 7
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-642L2F.docx
08/19
Installation
A typical desk-edge subset installation is shown below (see Figure 4).
WARNING
—Do not install this equipment in hazardous areas. Such installations may cause a
safety hazard and consequent injury or property damage.
1.
Remove the mounting angle from the subset.
2.
Secure the mounting angle to the mounting surface using the two screws and the 0.203 inch (5.16
mm) mounting holes.
3.
Re-connect the subset to the mounting angle with the screws provided.
4.
Plug the subset cable into the amplifier enclosure and secure the connector with the connector guard
(located on the amplifier enclosure).
Figure 4. Typical desk-edge installation
Operation
GAI-Tronics offers two types of Page/Party systems; single party, with one page line and one party line,
and multi-party, with one page line and five party lines, allowing up to five simultaneous two-way
conversations.
Single Party Systems
Complete the following steps to make a page announcement:
1.
Lift the handset from the cradle.
2.
Depress and hold the handset pressbar.
3.
Speak directly into the microphone to broadcast a page announcement over the loudspeakers.
4.
Release the handset pressbar, and if requested, wait for a response.
The paged individual(s) responds by picking up a station handset.