Pub. 42004-519C
Rugged VoIP Autodial Handset Telephones
Page 9 of 26
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-519C.docx
10/19
Model 247-700
The mounting and cabling instructions for
the Model 247-700 Telephone are as
follows:
1.
Remove the four screws from the front
panel.
2.
Remove the front panel and set it aside.
3.
Mount the enclosure to a wall using
either four ¼-20 machine screws with
washers and nuts or four #14 wood
screws of the appropriate length,
depending on the mounting surface.
There are four mounting holes in the
rear enclosure (see Figure 10).
4.
Drill a hole for the type of bushing to be
used.
5.
Pull the Ethernet cable through the
bushing and install the cable (see the
Network section).
6.
Seal the conduit entry point.
N
OTE
:
Use silicone sealant or equivalent around and inside all cable/conduit entries.
7.
Connect and configure any desired peripheral devices (see the Auxiliary I/O section).
8.
Perform the initial programming of the telephone (see the Programming section).
9.
Verify telephone operation by calling to and from another telephone.
10.
Test the operation of peripheral equipment.
11.
Replace the front panel assembly.
12.
Secure the front panel using the four front-panel screws.
13.
Torque the screws to 10–12 in∙lb (1.1–1.4 N∙m).
Figure 9. Model 247-700 VoIP Autodial Telephone
