3905C 100621
4
NX Energy Dashboard
INSTALLATION GUIDE
To NX Area Controller
To PC/LAN
NX Area Controller, Interior
From NX energyHUBB
Figure 4: Network Connections
Starting Up energyHUBB Controller
1. Energize the circuit feeding the NX energyHUBB to power it up. Make sure to close the circuit breaker next to the
energyHUBB module inside the enclosure.
2. Ensure the PC is connected to the system and to the NX Area Controller as described in the previous section.
3. There are two RJ-45 Ethernet ports on the NX energyHUBB module (as shown in Figure 4). The primary port is
dedicated for connection to the NX Area Controller. Its default static IP address is
192.168.1.2
4. The secondary port of your NX energyHUBB ships with a static default IP address (
192.168.0.3
) from the factory. This
port is dedicated for customer connection, such as to your PC or your building LAN router.
5. To ensure energyHUBB has been connected properly and functioning, you need to connect your PC directly to the
NX energyHUBB module and make sure you can get to the dashboard login in screen.
In order to do this, you will need to follow some steps outlined below, starting with changing your computer’s
network adapter settings to be in the same network as energyHUBB.
6. In your network adapter settings, click on “Change Adapter Settings”, then click “Ethernet”.
a. Go to Ethernet Properties and select “Ethernet Protocol Version (TCP/IPv4) as shown above.
701 Millennium Blvd. | Greenville, SC 29607 | (864) 678-1000 | hubbellcontrolsolutions.com
Copyright © 2021 Hubbell Control Solutions, a division of Hubbell Lighting, Inc. All rights reserved. All product and company names, logos and product
identifiers are trademarks ™ or registered trademarks ® of Hubbell Lighting, Inc. or their respective owners. Use of them does not necessarily imply any
affiliation with or endorsement by such respective owners.
