If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH
•
CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge
®
. All rights reserved.
30801
Installation Instructions
To Mount Fixture to Wall
(Figures 1 & 2)
(Continued)
6. Thread the wires in the electrical box through the center
hole in the mounting bracket (B) while moving the bracket
into position. Using the #10 screws (D), screw the bracket
securely to the wall. Be careful not to over-tighten or strip
the anchors.
7. Hold the fixture assembly (A) close to the mounting bracket
and using suitable wire connectors (not provided), connect
fixture wires to supply wires (white to white and black to
black). Run a pigtail lead from the crossbar ground screw
(F) and cupped washer (G) to the electrical box and connect
all ground wires (bare copper or green to bare copper or
green).
CAUTION:
MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRES ARE EXPOSED.
8. Apply a generous bead of a suitable caulking material to
caulking lip (I) on fixture. (Figure 2)
9. Carefully tuck all wires behind the fixture assembly (A) and
inside the mounting bracket and place the fixture firmly onto
bracket (B) and fasten with #8 screws (E) and rubber
washers (H) on top.
10. Install two remaining #8 screws (E) in bottom of fixture
attaching to mounting bracket (B).
To Install Glass
(Figures 3 & 4)
Component Parts
A Fixture Assembly
J Glass Panel (4)
K Glass Clip (4)
L Glass Shelf (4)
M Bulb (not provided)
1. There are two sizes of glass (J) for this fixture. The two taller
panels go in the front of the fixture and the two shorter
panels go in the back of the fixture. The flat end of the glass
will go towards the top of the fixture. Tapered end towards
bottom.
See Figure 3 for orientation.
2. Install bulb (M) into fixture. (bulb not provided)
B320
Elton Outdoor Sconce 303050, 303053 & 303055
Page 2 of 3
(Figure 3)
(Continued)
FIXTURE FRONT
TALL GLASS PANELS
SHORT GLASS
PANELS
FIXTURE BACK
