45136
ASSEMBLY & INSTALLATION INSTRUCTIONS
Double Ursa 302507
B427
To Install Fixture
(Figures 1 & 2)
CAUTION:
FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE.
We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution:
Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.
CAUTION:
BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.
3 OF 8
1.
Carefully unpack the fixture (A) from the carton.
2.
The fixture is wrapped in plastic wrap. Remove plastic wrap and foam block.
3.
Locate the mounting bracket (B), found in the kit bag.Thread the wires in the electrical box through the hole
in the mounting bracket (B) while moving the bracket into position.
Using (2) #8 machine screws (not pro
-
vided), attach the bracket securely to the junction box. Make sure bracket is level. (Figure 2)
Note:
A new electric box comes with screws. When replacing an existing fixture, retain screws for use with
the new fixture
4.
Attach a pigtail lead to the mounting bracket (B) using the ground screw (F) and cupped washer (G) found
in kit bag.
5.
Orient fixture (A) such that the glass shield is facing upward.
6.
Hold fixture (A) close to wall. Using suitable wire connectors (not provided), connect fixture wires to supply
wires (white to white and black to black). Connect all ground wires (bare copper or green to bare copper or
green).
7.
Apply a generous bead of a suitable caulking material (not provided) to caulking lip (I) on the fixture (Figure
3).
8. Place fixture (A) over mounting bracket (B). Secure with #8 screw (E) and rubber washers (H) on top and
#8 screws (E) in bottom of fixture. Be sure no wires are pinched between fixture and wall.
CAUTION:
MAKE SURE WIRE CONNECTORS ARE TWISTED ON SECURELY, AND NO BARE WIRE IS
EXPOSED.
