14
live wire outlet; when the instrument voltage is input from the live wire outlet, the clamp meter
should be connected to the live wire inlet; attention is paid to the current direction of the clamp
meter, and the current flows from the clamp meter "+" into "-")
4. Connect the photoelectric sampler or pulse line to the instrument pulse interface, and connect
the electric meter end to the corresponding interface;
5. Open the "terminal power supply" to start;
6. Move [← →] cursor to the photoelectric or manual mode, active and reactive power, move to
the target and determine, continue moving the [← →] key to the electric meter series key and
input item, and press [↑↓] to select the corresponding electric meter series and 50A clamp
"meter".
7. Press [set] and the cursor is normal, and input "1600";
8. Press [↑↓] and move the cursor to the number of laps, and input "1"; (set a corresponding big
one if the current is big)
The setting parameters are shown in the figure below:
9. After the settings, click [Confirm] key to begin with calibrating;
10. If there is a need to save the data, press [Storage] key, and enter the storage interface.
11. Move the cursor to the "user number" column on the store screen by [↑↓], press [Switch] key
to switch the input method to
and input 3951082 (
if it is mistyped, press [F5] to single
delete, and press [F3] to delete the entire line
); then move the cursor to the "user name"
column by [↑↓], press [Switch] key to switch to
, use the English input method to input
"LINAN", move the cursor by [↑↓] to the "meter number" column, and press [Switch] key to switch
the input method
and input 2096157 (
if it is mistyped, press [F5] to single delete, and
press [F3] to delete the entire line
); move the cursor by [↑↓] to the "inspector" column, press
