Connecting Cables
Requirements for making a network cable:
● Cut the cable of proper length based on the distance between the AP and the PSE device, peel the insulation on
both ends of the network cable, and crimp the wires to RJ45 connectors.
● Connect RT45 connectors to the network cable tester to test cable connectivity. The following shows the pin
assignment.
The service network cable cannot be connected to the console port. Otherwise, the AP may be damaged when using
PoE power supply.
CAUTION
X1 Pin
1
2
3
4
5
6
7
8
X2 Pin
1
2
3
4
5
6
7
8
Wire Color
White and orange
Orange
White and green
Blue
White and blue
Green
White and brown
Brown
7
CAUTION
When using WA635SN-GN Aps to replace WA633SNs, you need to prepare
adapters, such as SMA-to-N type adapters (figure a and b). Alternatively, make new
feeder lines matching the connectors of WA635SN-GN Aps (figure c).
a
b
c
1
2
4
Ground cable
3
The M4 connector is connected to the WA635SN-GN and the M6 connector is connected to
the ground bar.
Description
SN
Name
Power
adapter
12 V DC
Network
cable
RF cable
● The WA635SN-GN supports PoE power supply and DC power supply.
● Use the power adapter attached with the WA635SN-GN; otherwise, the WA635SN-GN
may be damaged.
Connect AP interfaces with antennas to transmit signals, or connect the AP with a combiner
that uses the same DAS with the AP.
● The network cables used are category-5 twisted pairs.
● If the AP needs to connect to the Ethernet, ensure that the Ethernet cable is working
properly. If the Ethernet cable is not working properly, for example, RJ45 connectors are
short-circuited, the AP may fail to be powered on or fail to work. Before connecting an
ethernet cable to the AP, use the cable test tool to check whether the cable is qualified. If the
cable is unqualified, replace it.
NOTE
1. The antennas used must comply with
local laws.
2. In North America or other regions that
Require FCC certification, use W5030H
antennas from Pulse.
