Huawei V100R008, Руководство пользователя

Страница: 44 / 141

ViewPoint 8650C
User Guide
5 Holding a Simple Conference
Issue 10 (2013-07-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
36
Table 5-1 IP address planning
Name IP address Subnet mask Gateway address
SC 200.53.24.11 255.255.0.0 200.53.0.1
Computer / Data
Base 200.53.24.11 255.255.0.0 200.53.0.1
8650C 200.54.1.101 255.255.0.0 200.54.0.1
Table 5-2 shows the participant data planning.
Table 5-2 Participant data planning
Site Name Terminal Number Other Information
Site1 0100001 Device type: Terminal
Site type: IP
Rate: 768 kbit/s
Password: 123456
Contact: Rose
Telephone: 01087654321
Email: rose@rmcc.com
The Email notification function is not
enabled.
Site2 0100002
Site3 0100003
Define each IP terminal as an IP participant on the RM and an endpoint on SC respectively.
The IP terminal, IP participant, and endpoint are associated by the same terminal number. The
IP participant should meet the following requirements:

Terminal number: The parameters on the RM (terminal number of the IP participant), the
SC (Endpoint number) and the terminal (terminal number) must be consistent with each
other.

Terminal password: If the SC adopts the password authentication, the terminal password
of the IP participant defined on the RM, the node password defined on the SM, and the
registration password of the IP terminal should be the same.
5.1.2 Configuring the Parameters Between the 8650C MCU and
the RM
To use a terminal to hold a conference with the RM, the SC, and the MCU, you need to set the
connection parameters for the MCU and the RM.
Step 1
Log in to the 8650C web interface.
Step 2
Choose Settings > System > RM Connection .
The RM Connection page is displayed, as shown in Figure 5-1 .