class-name
in this step must be the same as the name of the traffic class created in
Configuring Traffic Classification Rules
In this step,
behavior-name
must be the same as that specified in
when you configure the
traffic behavior.
Step 4
Run:
quit
Return to the system view.
Step 5
Run:
interface
interface-type
interface-number
The interface view is displayed.
Step 6
Run:
traffic-policy
policy-name
inbound
The traffic policy that contains flow mirroring is applied to the interface.
You can repeatedly perform
and
to monitor the incoming flows, with the same
attributes, passing through multiple interfaces.
----End
7.11.5 Checking the Configuration
Run the following commands to check the previous configuration.
Action
Command
Check information about the
observing port.
display observe-port
Check information about port
mirroring.
display port-mirroring
Check the flow mirroring
configuration in the traffic policy
on an interface.
display traffic policy
interface
[
interface-type
interface-number
] [
inbound
]
If the following results are obtained, the configuration is successful:
l
The observing port is configured properly.
l
A proper traffic policy is applied to the interface where incoming flows need to be
monitored.
l
The traffic policy contains a proper traffic classifier and a traffic behavior and the traffic
behavior contains a flow mirroring action.
7.12 Configuring Remote Flow Mirroring
This section describes how to configure remote flow mirroring.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management
7 Mirroring
Issue 01 (2011-07-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
87
