Figure 6-6 Installing the new micro SD card and anti-theft board
Step 4 In any view, run the display sd-card information command to check the micro SD
card installation and file system mounting status. In the command output, SD
Card Physical State should be Present, and SD Card File System State should be
Mounted.
●
If SD Card Physical State is Absent, re-install the micro SD card and try
again. If SD Card Physical State remains the same, the USG may fail to
identify the micro SD card. You are advised to use another micro SD card.
●
If SD Card File System State is Unmounted, the micro SD card format might
not be ext4. You need to run the reset sd-card command in the system view
to format the micro SD card.
----End
Follow-up Procedure
After replacing the micro SD card, collect all tools. If the replaced micro SD card is
faulty, fill in the
and send the faulty module with the
Repair Transmission Sheet to the equipment supplier or the specified repair service
provider.
6.5 Replacing a Device
Context
When a fault occurs on the USG device, such as a memory fault, CPLD fault, or
startup failure, you can replace the USG device to rectify the fault.
HUAWEI USG6000E Series
Hardware Guide
6 Maintaining the Hardware
Issue 08 (2022-04-20)
Copyright © Huawei Technologies Co., Ltd.
589