Huawei U-SYS IAD101H, Быстрый старт

Страница: 9 / 19

U-SYS IAD101H/102H/104H Integrated Access Device
Quick Start
4
Configuration (Command Line Mode)
Issue 02 (2011-02-09) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7
If you cannot access the IAD by the preceding method, set the IP address of your PC to the
same IP address segment as “1.1.1.1” and the subnet mask to 255.255.255.0. If you can ping
1.1.1.1 successfully, enter
telnet 1.1.1.1
in the
Run
dialog box to log in to the IAD.
----End
P.S. How to Log In to the IAD104H
Connect your PC to the IAD through a serial cable. Choose
Start
>
Programs
>
Accessories
>
Communication
>
HyperTerminal
, select “COM1” in the
Connect To
dialog box (If logging in to the CLI fails, select COM2). In the
COM1 Properties
dialog box, click
Restore Defaults
and click
OK
. Press
Enter
on the HyperTerminal
interface. After the welcome interface is displayed. Enter the user name (
root
by
default) and password (
admin
by default).
4.2 IAD(SIP) Accessing NGN/IP PBX
When the network is normally connected, if the IAD registers with the SIP server (for
example, Softswitch) successfully, it can implement the voice call function.
Data Preparation
Before configuring the IAD, you should obtain the following items of data from the
administrator.
Item Data Example
IAD IP address The IP address is obtained through dhcp. (You can
consult the network operator for how to obtain the
IP address of the device.)
IP address of the SIP Server 191.168.10.20
SIP user ID 88880008
Procedure
Step 1
Log in to the CLI with the user name
root
and password
admin
, and then run the
following commands to enter the global configuration mode.
Enter the privilege mode.
TERMINAL> enable
Enter the global configuration mode.
TERMINAL# configure terminal
(Optional) Set the system timeout interval to the maximum to avoid logging in to the
IAD regularly (the timeout interval is 5 minutes by default).
TERMINAL(config)# terminal timeout 255