Mounting on the wall
It is recommended that the port be facing down to prevent other objects such as dust from
falling in for wall mounting, as shown in the following figure.
1.
Mark two positions with the same spacing as that between the two mounting holes of the
ONU using a marker on a wall.
2.
Select a proper drill bit according to the outer diameter of the screws. Use a hammer drill
to drill the marked positions on the wall. Then clean the holes and install two expansion
bolts.
It is recommended that the screw diameter be less than or equal to 4 mm, the nut diameter be 6 to
8 mm, and the length should not be less than 20 mm.
3.
Use a screwdriver to fasten the screws into the expansion bolts, reserving 5 mm ends out
of the wall, and mount the ONU onto the screws.
OptiXstar P622E
Quick Start
2 Installing the Device
Issue 01 (2019-09-30)
Copyright © Huawei Technologies Co., Ltd.
4
