Huawei OceanStor 5300 V3, Быстрое руководство по установке

Страница: 21 / 25

5a
Switching on external power supplies
Turn on external power supplies in the following sequence:
disk enclosures
→ controller enclosures → switches (for a SAN) → application servers.
Checking cable connections
4a Checking device installation
4b
Check Item Normal Abnormal
Controller
enclosure

The device sits stably on the guide rails
without displacement.

Screws are properly secured.

The device slants or cannot be detected.

Screws are loose or have fallen off.
Disk enclosure
Check Item Normal Abnormal
Ground cable, optical
fiber cable, mini SAS HD
electrical cable/optical
cable, network cable,
and serial cable
The cable is fully inserted and secured. The cable is loose or disconnected.
AC power cable

The AC power cables for each controller
enclosure or disk enclosure are connected to
two separate power supplies for redundancy.

The AC power cables are secured with
plastic buckles.

The AC power cables for each controller
enclosure or disk enclosure are
connected to the same power supply.

The AC power cables are not secured
with plastic buckles.
DC power cable
The OT terminal of the black cable
connects to the RTN (+) terminal and the
OT terminal of the blue cable connects to
the NEG (-) terminal. The OT terminal of the blue cable
connects to the RTN (+) terminal and
the OT terminal of the black cable
connects to the NEG (-) terminal.
4 Checking Hardware Installation
5 Powering On the Storage System

To avoid electric shock, do not wear an ESD wrist strap when the storage system is powering on.

Do not change cable connections between enclosures after power-on. Otherwise the storage system may
malfunction.

Follow the correct power-on sequence of the storage system: Turn on the external power supplies to each
device (disk enclosures first and then controller enclosures).
→ Press the power buttons on the controller
enclosures.
→ Power on the switch. → Power on the application servers.

Follow the correct power-off sequence of the storage system: Stop host services.
→ Press and hold down the
power buttons (typically for five seconds) on the controller enclosures until the system is powered off.
→
Disconnect the controller enclosures and the disk enclosures from their power supplies.
The power-on of the storage system takes 15 to 30 minutes. When the power indicator on the controller enclosure no longer
blinks, the power-on is completed.
Scenario 1 Turning on the switches of the power
distribution box
Scenario 2 Turning on the switch of the PDU
Front
Rear
Front
Rear
21
NOTICE