5.2.3 Connect Device Cable
l
Connect device corresponding power, video output, audio cable and RS485 control cable
to external cable well according to requirement, and then use insulated tape to twine the
connection respectively to make it waterproof.
NOTE
Please be noted that the bending radius of optical fiber needs to be no less than 30mm when
connecting to optical fiber.
l
Connect network cable to corresponding network port of the device cable according to
Install Waterproof Connector (Optional)
.
Install Anti-drop Rope
l
When the device adopts wall-mounted installation mode, it needs to hang one end of
both anti-drop ropes on the hook of the device bottom, and then hang the other end of
both anti-drop ropes on the two hooks of the installation bracket.
l
When the device adopts pendant installation mode, it needs to hang one end of both anti-
drop ropes on the hook of the device bottom, and then hang the other end of both anti-
drop ropes on the two hooks of the adapter block.
Install Waterproof Connector (Optional)
The installation process of waterproof connector for network port is shown in
.
NOTE
It needs to implement the operation when the device is equipped with waterproof connector and it is
used outdoors.
Figure 5-3
Waterproof connector installation
Step 1
Keep the convex groove outward and install the rubber ring into the network port, keep the
smaller hole of the rubber ring outward and install the fixing rubber ring into the main body
of the waterproof connector.
Step 2
Pull the network cable without crystal head through main body of waterproof connector,
fixing rubber ring and waterproof locking cover, make the crystal head of network cable, and
then insert it into the network cable.
Step 3
Put the main body of waterproof connector on the network port and rotate it clockwise to lock
the network port and waterproof connector firmly.
IPC6091-P360
Quick Start Guide
5 Device Installation
Issue 01 (2019-02-22)
Copyright © Huawei Technologies Co., Ltd.
13
